When a sump pump stops doing its job, the failure is usually in one of two components. The float switch tells the pump when to run, and the motor does the running. Most of the calls that come in as a dead pump turn out to be a switch problem, which is good news: a switch is a repair, while a seized motor on an older pump often means replacement.
A float switch fails in two directions, and the symptom tells you which. Stuck down means the pump never starts — the water rises and nothing happens, usually because the float has drifted against the pit wall, caught on the discharge pipe or the power cord, or fouled with silt and gravel. Stuck up means the pump never stops, so it runs dry, heats up and eventually burns out the motor it was supposed to protect. The simplest diagnostic in this whole trade is lifting the float by hand: if the pump starts, your pump is fine and the switch or its clearance is the problem.
Motor symptoms are different. A motor that hums without moving water usually has a jammed or broken impeller, or a seized bearing. A motor that trips the breaker on startup is drawing too much current, typically from a failing winding or a locked rotor. A motor that runs but moves little water is often fighting a clogged intake screen or a failed check valve rather than being faulty itself — which is why we check those before condemning a pump.
We diagnose rather than swap on suspicion. Replacing a pump that only needed a twelve-dollar switch is an expensive guess, and replacing a switch on a pump whose motor is already heat-damaged just means you are back on the phone after the next storm. Either way you get the finding and the exact price before we touch anything.
Technician insight
Nine times out of ten the pump that 'died' has a float wedged against a discharge pipe that somebody bumped while moving storage boxes. Before you call anyone, take the lid off and look at whether the float has room to swing. It is the cheapest sump pump repair in the world and it takes thirty seconds.
Float Switch and Motor Repair Services We Offer
✓Float Switch Replacement
New tethered, vertical or diaphragm switch fitted and set to correct start and stop levels for your pit depth.
✓Stuck Float Correction
Clearing debris, correcting float clearance and rerouting the power cord and discharge pipe so the float can travel freely.
✓Impeller Cleaning and Replacement
For pumps that hum or run without moving water because the impeller is jammed, worn or broken.
✓Motor Diagnosis and Replacement Advice
Current draw and bearing checks, with a plain recommendation on whether the pump is worth keeping.
How it works
- 1
Electrical Check First
Outlet, GFCI and breaker before anything else, because a dead circuit presents exactly like a dead pump.
- 2
Isolate the Switch
We lift the float by hand. Pump starts means the switch or its clearance is at fault; pump stays silent with good power points to the motor.
- 3
Inspect the Wet End
Impeller, intake screen and check valve are checked before any motor is written off, because all three can mimic a motor fault.
- 4
Repair With the Price Agreed
You get the finding and exact price first. Switch and impeller work is usually completed the same visit.
Pricing
Switch repairs sit at the low end of our range; motor findings are quoted against the cost of replacement so you can compare.